CRI Atom Encoder for console has options below.
Specify the directory to refer it when a directory for files in the csv file is not written.
Generate an ACB file too when generating the AWB file.
Generate .acb and _acb.h with the same name with the AWB file to the same output destination as the AWB file.
Specify the encode codec when the input is a directory. Available codecs are below: ADX, HCA, HCAMX
Specify the sampling rate for encoding.
If not specified, the sampling rate of the source audio file is used.
Available sampling rates are below:
48000, 44100, 32000, 24000, 22050, 16000, 12000, 11025, 8000
Specify the quality for re-sampling when the sampling rate is specified.
| DEFAULT | (Default) Fast resampling |
| HIQUALITY | Precise resampling |
Specify the encode quality.
Not available for ADX codec.
| HIGHEST | Highest quality |
| HIGH | (Default) Higher quality |
| MIDDLE | Medium quality |
| LOW | Lower quality (Higher compress rate) |
| LOWEST | Lowest quality (Highest compress rate) |
Specify the volume gain.
The available value range is from 0.0 to 5.0.
The default value is 1.0.
If a large value is given, the amplitude might be saturated.
Specify the cut-off frequency if the encode codec is HCA or HCAMX.
The unit is [Hz].
Ignore the loop information embed in the input audio file and specify the loop start position.
The unit is sample position.
Ignore the loop information embed in the input audio file and specify the loop end position.
The unit is sample position.
Ignore the loop information embed in the input audio file and specify the whole loop.
Ignore the loop information embed in the input audio file and specify no-loop.
Encode without removing samples after loop end point.
Available for ADX, HCA and HCAMX codec.
If you have a project of CRI Atom Craft which has a commercial license, Specify the file of the project (.atmcproject).