Block transition setting

By setting a Block transition destination from the Inspector, you can set the behavior when a block is played to its end without a transition destination being specified.

About the Block transition destination setting value

Item	Description
None	Playback will stop at the end of the block.
Next Block	If there is a next block, playback will move to that block.
Specify Block transition destination	You can make a block transition in a specified way.

Specify Block transition destination

If you specify a Block transition destination, the transition will be made to the blocks registered in the "Block transition Destination List" according to the specified type.
You can choose from one of the following four types:

Item	Description
Sequential	The transitions start from the first block in the list. When the transitions reach the end of the list, the transitions start from the first block in the list again.
Shuffle	Randomly rearranges the blocks on the list and transitions. When all elements on the list have been transitioned, randomly rearrange the elements on the list again and transitions.
Random	The transition to the block will occur with a probability based on the "weight" setting.
Random No Repeat	The transition to the block will be determined by the probability based on the "weight" setting. The transition will always be to a block different from the original block.

Note

The weight values ​​that can be specified for Random and Random No Repeat are calculated with the total value on the list as 100%.
Also, there is no transition to blocks with a weight of 0.

Registering to the Block transition list

This can be done from [Block] in the Inspector.
Click the [Add] button to add your block to the list.
Pressing the [Delete] button will remove the currently selected block from the list.

You can change the blocks that are candidates for a transition by clicking on the block name item in the list.