CriWare Unreal Engine
Plug-ins for CriWare solutions.
Loading...
Searching...
No Matches
FAtomBusEffectLimiterSettings Struct Reference

#include <AtomBusEffectLimiter.h>

Public Member Functions

 FAtomBusEffectLimiterSettings ()

Public Attributes

float AttackTime
bool bBypass
float Gain
float ReleaseTime
float SidechainGain
float SidechainMixRatio
float SurroundLink
float Threshold
EAtomLimiterType Type

Constructor & Destructor Documentation

◆ FAtomBusEffectLimiterSettings()

FAtomBusEffectLimiterSettings::FAtomBusEffectLimiterSettings ( )

Member Data Documentation

◆ AttackTime

float FAtomBusEffectLimiterSettings::AttackTime

Specifies the attack time of the limiter in milliseconds. The time until compression is completed.

◆ bBypass

bool FAtomBusEffectLimiterSettings::bBypass

If true, input audio is directly routed to output audio with applying any effect.

◆ Gain

float FAtomBusEffectLimiterSettings::Gain

Specify the final output gain of the limiter in decibels (dB).

◆ ReleaseTime

float FAtomBusEffectLimiterSettings::ReleaseTime

Specifies the release time of the limiter in milliseconds. The time from when the amplitude becomes below the threshold until the end of compression.

◆ SidechainGain

float FAtomBusEffectLimiterSettings::SidechainGain

Specifies the gain of the sidechain signal in decibels (dB).

◆ SidechainMixRatio

float FAtomBusEffectLimiterSettings::SidechainMixRatio

Specifies the mix ratio between the sidechain signal and the original bus signal in percent. 100% uses only the sidechain signal, while 0% uses only the original bus signal.

◆ SurroundLink

float FAtomBusEffectLimiterSettings::SurroundLink

Specify the surround link strength of the limiter. Surround link function changes the compression strength using the lowest amplitude value in all channels. 100% fully uses the lowest amplitude value in all channels, while 0% turns off the surround link function.

◆ Threshold

float FAtomBusEffectLimiterSettings::Threshold

Specifies the limiter threshold for amplitude compression in decibels (dB).

◆ Type

EAtomLimiterType FAtomBusEffectLimiterSettings::Type

Specifies the limiter amplitude detection value type.


The documentation for this struct was generated from the following files:
  • C:/git/uev2/Engine/Plugins/Runtime/CriWare/CriWare/Source/CriWareCore/Public/Atom/Effects/AtomBusEffectLimiter.h
  • C:/git/uev2/Engine/Plugins/Runtime/CriWare/CriWare/Source/CriWareCore/Private/Atom/Effects/AtomBusEffectLimiter.cpp