Material

In CRI Atom Craft, wave files imported into a project are called materials.

The material is given encoding information read from the wave file.

The waveform files that can be used on this tool are as follows.

Format WAV (.wav) files, AIFF (.aif, .aiff) files
Number of channels 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 12, 16
Number of bits 8 bits, 16 bits, 24 bits, 32 bits (Float)

The order supported by each Number of channels is as follows.
Even if a channel has multiple settings, you cannot use different settings in the same project.
Please standardize the configuration by channel.
Settings can be changed from their default values at Global Project Settings .

Number of channels Order (★ indicates default value)
1 ch Mono (output is L, R virtual center)
2 ch Stereo (L, R)
3 ch ★L, R, C
L, R, Cs
4 ch ★L, R, Ls, Rs
Ambisonics 1st order
5 ch ★L, R, C, Ls, Rs
L, R, Lfe, Ls, Rs
6 ch L, R, C, LFE, Ls, Rs
7 ch L, R, C, LFE, Ls, Rs, Cs
8 ch ★L, R, C, LFE, Ls, Rs, Lb, Rb
L, R, C, LFE, Lb, Rb, Ls, Rs
L, R, C, LFE, Ls, Rs, Lt, Rt
9 ch ★Not set
Ambisonics 2nd order
10 ch ★Not set
L, R, C, LFE, Ls, Rs, Lb, Rb, Lt, Rt
L, R, C, LFE, Lb, Rb, Ls, Rs, Lt, Rt
12 ch ★Not set
L, R, C, LFE, Ls, Rs, Lb, Rb, Ltf, Rtf, Ltb, Rtb
L, R, C, LFE, Lb, Rb, Ls, Rs, Ltf, Rtf, Ltb, Rtb
16 ch ★Not set
Ambisonics 3rd order
Attention
Waveform files that have already been encoded as .adx or .hca files cannot be registered. (Support to be provided in the future)